No Days Adhesives Groutless

Product Size: 12″ x 12″ (30.5cm x 30.5cm) Sheet, 1 Sheet in Black, Pewter or Clear

Tile Glue and Grout for Micro Mosaics and Jewelry

NO Days Groutless is a thick, heat activated adhesive sheet designed not only to adhere tiles to a variety of substrates but also to fill in your grout lines during heating.

NO Days Mosaic Adhesive Product Benefits

  • Bonds to a variety of surfaces (direct method)
  • Designed for both interior and exterior application
  • Quicker and cleaner than using liquid or cement adhesives
  • Clear film design allows you to see or trace your pattern
  • Non-toxic, no fume byproduct
  • Available in sheets or rolls

NO Days Groutless Adhesive Product Benefits

quickly secures glass, ceramic and stone tiles to substrates
thick adhesive sheet design fills in grout lines during heating
one step glue and grout process
easily cut dry adhesive sheet to size match your substrate
activate adhesive with a heat gun or embossing heat tool
quick curing, non-toxic and easy to apply
glass tiles are re-workable, just re-apply heat
best of all……NO need to grout at the end!

Groutless provides you a one step process by allowing you to use your glue as your grout when creating glass art mosaics. Groutless is delivered in a dry to the touch adhesive sheet and can be cut to size to match the size of your substrate. Full size or cut sheets can also be placed side by side to cover larger or custom size substrates, and can be layered to fill in gaps and larger grout lines.

How to create Groutless Mosaics with NO Days

Step 1: Cut the Groutless Mosaic Adhesive to the size of your substrate using scissors or craft blade.

Step 2: Place the cut adhesive sheet on top of your substrate and begin to build your mosaic with glass, ceramic or stone tile.
NOTE: If there are gaps between the tiles that are greater than 1/16″, you’ll need to use a tool (like tweezers or a skewer) to move the pieces around while you’re heating. Pushing the pieces closer together, while the adhesive is heated, will cause the adhesive to fill in and “Grout” the gaps.

Step 3:  When finished placing all your tile pieces on top of your substrate, begin heating using a standard heat gun or embossing heat tool set to low.  Hold the heat gun approximately 6″ to 8″ above your piece to gradually heat the adhesive and tiles.

NOTE:  Avoid holding the heat gun or embossing heat tool too close to your tiles as this can cause small tile pieces to shift.  As the pieces heat up, the adhesive will begin to liquify.  While heating, apply slight pressure to the tiles with a hand tool so the adhesive begins to surround and fill the gap between tile pieces.

Step 4:  When finished heating, you will have approximately one minute to continue to shift tiles around while the adhesive cools, sets and cures.  When the adhesive is fully cooled, your mosaic is now finished.  If you need to remove or re-position any tile pieces, simply re-heat, adjust and allow to cool again.

[srizonfbalbum id=3]